These nodes are designed for energenie RF radio devices in the OOK & FSK (OpenThings) ranges. NOTE: This module does not currently support the older boards (ENER314/Pi-Mote), the Energenie Wifi sockets or the MiHome Gateway (see below for the full supported list).

The number of individual devices this node can control is over 4 million, so it should be suitable for most installations! Non-Energenie 433Mhz Radio Controlled Devices Purple Mains Powered Control & Monitor Devices (DEPRECATED)

Within the 4 types there are currently 10 nodes available to use: NodeĪll Blue, Green & Legacy (OOK) Energenie Devices Green for sending any OOK or FSK raw byte array (Advanced node).Purple for monitoring and controlling 'Control & Monitor' FSK/OpenThings devices.Pink for monitoring MiHome 'Monitor' FSK/OpenThings devices.Blue for switching ' Control' OOK based devices.There are 4 types of node to match the colour coding of the Energenie MiHome devices: 'Control', 'Monitor' and 'Control & Monitor' radio based devices are supported from the legacy and MiHome range. This is instead of operating the devices using a MiHome Gateway, so this node does not require an internet connection. On a Raspberry Pi with an ENER314-RT board installed using node-red (see below for full list). You can use this node-red module to control and monitor the Energenie MiHome radio based smart devices such as adapters, sockets, lights, thermostats and relays Npm install node-red-contrib-energenie-ener314rtĪ node-red module to control the Energenie MiHome line of products via the ENER314-RT add-on board for the Raspberry Pi. Node-red module for energenie ENER314-RT board for raspberry pi Node-red-contrib-energenie-ener314rt 0.5.1

Bluecontrol license number